Hey all, been looking around for someone with good machining skills and access to the right equipment to make me a specific part I have in mind...
I want to make a shotgun barrel/magazine clamp that's a bit longer than the usual. Think something like this:
http://www.shop.countrysidewalk.com/Shotgun-Clamp-with-Light-Mount-SMC-1100.htm
But that wraps around the barrel completely, and is about 4" long. Here's a shot of a similar item:
http://img716.imageshack.us/img716/3364/rtx374.jpg
Basically, a double shroud that fits around the barrel and mag (could be two pieces, top and bottom), that connects and tightens with cross screws (like most of these clamps).
Anyone have any recommendations? I'm located in the Boston area.
Thanks!
I want to make a shotgun barrel/magazine clamp that's a bit longer than the usual. Think something like this:
http://www.shop.countrysidewalk.com/Shotgun-Clamp-with-Light-Mount-SMC-1100.htm
But that wraps around the barrel completely, and is about 4" long. Here's a shot of a similar item:
http://img716.imageshack.us/img716/3364/rtx374.jpg
Basically, a double shroud that fits around the barrel and mag (could be two pieces, top and bottom), that connects and tightens with cross screws (like most of these clamps).
Anyone have any recommendations? I'm located in the Boston area.
Thanks!