Obv I know where you work but I didn't know you had the patience and time to do **** up a PSL by doing a screw build.
I just got rick-rolled.
I just got rick-rolled.
If you enjoy the forum please consider supporting it by signing up for a NES Membership The benefits pay for the membership many times over.
Be sure to enter the NES/MFS June Giveaway ***Keltec SUB2000***
Well got 90% done demilling my parts kit today. I'm thinking ill leave the front trunnion and sight block for when I start the barrel work. Ill drill the long rivets on the rear at work on the bridge port.
Luckily my dad has a press, front sight post was a bitch. Couldn't believe how easy the flash hider came off. Unscrewed it by hand lol .
I would just paint it. But I don't really care about finish unless I'm trying to recreate a "look."
If you were super worried about rusting, parkerize the whole rifle when it's assembled and then paint it.
atilla is a dick
Haven't placed the order on the barrel yet. wanted to wait for the parts kit and reviver to show up. I wanted to play it safe in case there was any problems.
So any one have a idea which way to punch the pins out? I know the barrel pin you need a press to get out.
Me a troll?
Funny thing is I told Atillia Saturday I was bringing it into work to drill out.
i don't listen when people speak. most of the time. i didn't listen.
screw builds are no joking matter.
flintoid is gonna punch me in the dick this weekend.
Try not to like it too much! Wear a cup made from a Russian infantry helmet.
these hit me right in the pride. [sad2]
i don't listen when people speak. most of the time. i didn't listen.
screw builds are no joking matter.
flintoid is gonna punch me in the dick this weekend.
these hit me right in the pride. [sad2]
True psl's have a third pin that's part of the saftey setup that the ATF worry a that it can be made into full auto etc.
So a Tapco G2 trigger kit is needed? Just wondering because I bought a kit unsure if I needed it.