So I'm looking into some new trigger job parts for my G19. I've checked out the "$.25 trigger job" but am wondering what connectors and springs anyone else is using/recommends (Sherrer, Ghost?). Thanks!
If you enjoy the forum please consider supporting it by signing up for a NES Membership The benefits pay for the membership many times over.
Be sure to enter the NES/MFS May Giveaway ***Canik METE SFX***
So I'm looking into some new trigger job parts for my G19. I've checked out the "$.25 trigger job" but am wondering what connectors and springs anyone else is using/recommends (Sherrer, Ghost?). Thanks!
The gun will be used for carry/home defense, so I probably don't want springs (I think) but am attempting to decide on a 3.5 connector. What set ups does anyone else have? Lone Wolf is spoken for, what about Sherrer, Ghost or Glocks OE con?
cheap and easy glock trigger job is the 3.5lb connector with the 10lb "New York" trigger spring.
keeps the ~ 5.5lb stock pull, with a slightly shorter reset.
the Ghost Tactical 4.5lb setup is rather nice too (buddy of mine has one on his G23).
I did my own trigger job on my G34.
it comes with a 3.5 pound connector.
I polished everything with a dremel.
I modified the trigger spring as well.
I cut a few coils off the firing pin spring.
I have 3-4000 rounds through it no issues.
I have not modified my carry G26 (aside from polishing it with a buffing wheel on a dremel)
How easy or hard is it to put one of these in myself?
How easy or hard is it to put one of these in myself?
I was lookin at THIS
Glock does not recommend polishing any of the internal parts, cutting springs or anything like that. id hate to see you guys send your glock in for a refurb only to have it sent home with a voided warranty when they see all the custom shit youve done to it.
glock also does not recommend a detail strip...
so confused... so many options and so many opinions.