pastera
NES Member
Posted as a joke in the "what have you done" thread and there was some interest in it so here it is.
This is prototype 3 and should sort quite reliably if you don't put cases on the slide at too much of an angle.
Holes in the feet are threaded 4-40 to attach to a plastic coffee can lid. Cut a hole in the lid below the 38 drop slot and you're done.
To use, just place the case on the slide and 38's fall through the drop and 357 roll off the end into a second container.
Print two feet and one each of the other parts.
You may need to do some cleanup on the slots or tabs for the front - the slots are a little tight.
The locking tabs should hold the slide on tightly but a little super glue will hold things together better
This is prototype 3 and should sort quite reliably if you don't put cases on the slide at too much of an angle.
Holes in the feet are threaded 4-40 to attach to a plastic coffee can lid. Cut a hole in the lid below the 38 drop slot and you're done.
To use, just place the case on the slide and 38's fall through the drop and 357 roll off the end into a second container.
Print two feet and one each of the other parts.
You may need to do some cleanup on the slots or tabs for the front - the slots are a little tight.
The locking tabs should hold the slide on tightly but a little super glue will hold things together better