• If you enjoy the forum please consider supporting it by signing up for a NES Membership  The benefits pay for the membership many times over.

Trijicon sites on M&P Shield

Joined
Aug 11, 2008
Messages
4,794
Likes
793
Location
Live Free or Die!
Feedback: 2 / 0 / 0
Good Afternoon Firearms Aficionados,

I was thinking of replacing the S&W OEM sites with Trijicon sights. Have any of you guys done this?

 
Last edited:
The rear site is a bitch to get off without the right pusher. If you have tools and experience not bad to do. If not bring it to reputable shop or smith. Truglo TFX pro on mine.

Good Afternoon Firearms Aficionados,

I was thinking of replacing the S&W OEM sites with Trijicon sights. Have any of you guys done this?

 
I used a very hard plastic drift and a very large hammer.. because of all the horror stories.. Sucker shot across the garage.. (Still looking for it and the front sight).. not that i was going to use them again......
Trijicons went in nice, No problems. Did not use the same hammer.....
Did an apex as well just get an armorers block.....if you do
 
Back
Top Bottom