bauer
NES Member
Hi all,
I’m In the early stages of considering my first ever SBR with an AR-9 lower I recently acquired and had a question in regards to properly sequencing the build.
Form 1, section 4 asks for barrel length and overall length which cannot be accurately determined/answered until I am in possession of the upper I intend to affix to the build with the requisite muzzle brake permanently attached for MA compliance.
I am aware I cannot of course assemble the rifle into SBR configuration until I have ATF approval and have engraved the lower, but to answer the questions on form 1 accurately, is it ok to acquire the SBR upper prior to approval or would this create concerns over constructive possession or anything similar?
Any help anyone could provide would be appreciated and my apologies in advance if this has been asked before (or ends up being a dumb question).
Thx all!
I’m In the early stages of considering my first ever SBR with an AR-9 lower I recently acquired and had a question in regards to properly sequencing the build.
Form 1, section 4 asks for barrel length and overall length which cannot be accurately determined/answered until I am in possession of the upper I intend to affix to the build with the requisite muzzle brake permanently attached for MA compliance.
I am aware I cannot of course assemble the rifle into SBR configuration until I have ATF approval and have engraved the lower, but to answer the questions on form 1 accurately, is it ok to acquire the SBR upper prior to approval or would this create concerns over constructive possession or anything similar?
Any help anyone could provide would be appreciated and my apologies in advance if this has been asked before (or ends up being a dumb question).
Thx all!