The Goose
NES Member
The press is an RCBS Pro 2000. I certainly cannot rule out that the double charge could have happened when weighing/checking the powder charge, but I do not think so. I have a routine. I do not pull out the case when it is under the powder dispenser I move it to the seating position and then pull it out before I pull the lever again. Then case goes back into that position and bullet is seated. I could check it less and may in the future, but I do not think that was it. The real interruption to the process came unclogging the APS priming strip. I should have just cleared everything at that point. However, I appreciate the feedback and will check the charge less in the future. At this point I will do about anything to make sure it never happens again.