took my chances and got 2 metric fal mags.. and after a little bit of work, it locks into the magwell, and feeds rounds.
one thing though is the FAL mag follower raised bullet bump sits higher than the SCAR mag one..
what i was wondering was, should i just hammer / dremel it down ? but i don't think it is thick enough for dremel work its just a thin sheet of metel
does anyone else know of where to get the OEM polymer SCAR 17 mag followers?
one thing though is the FAL mag follower raised bullet bump sits higher than the SCAR mag one..
what i was wondering was, should i just hammer / dremel it down ? but i don't think it is thick enough for dremel work its just a thin sheet of metel
does anyone else know of where to get the OEM polymer SCAR 17 mag followers?