1. If you enjoy the forum please consider supporting it by signing up for a NES Membership  The benefits pay for the membership many times over.

  2. Dismiss Notice

Metric FAL mag to Scar conversion

Discussion in 'Build it Yourself' started by Queen Bee, May 10, 2016.

  1. Queen Bee

    Queen Bee NES Member

    Joined:
    May 12, 2011
    Messages:
    2,733
    Likes Received:
    612
    Location:
    Massachusetts
    took my chances and got 2 metric fal mags.. and after a little bit of work, it locks into the magwell, and feeds rounds.

    one thing though is the FAL mag follower raised bullet bump sits higher than the SCAR mag one..

    what i was wondering was, should i just hammer / dremel it down ? but i don't think it is thick enough for dremel work its just a thin sheet of metel

    does anyone else know of where to get the OEM polymer SCAR 17 mag followers?
     
  2. pupchow

    pupchow NES Member

    Joined:
    Jan 3, 2008
    Messages:
    3,015
    Likes Received:
    541
    Anyone have any more recent info to add to this discussion?
     
  3. warwickben

    warwickben bubba Kalashnikov NES Member

    Joined:
    May 30, 2012
    Messages:
    19,904
    Likes Received:
    2,615
    Location:
    Kyben pass (tewksbury ma)
    Better off not touching the follower since it aids in the way the mag stacks rounds
     

Share This Page