Metric FAL mag to Scar conversion

[Queen Bee]

took my chances and got 2 metric fal mags.. and after a little bit of work, it locks into the magwell, and feeds rounds.

one thing though is the FAL mag follower raised bullet bump sits higher than the SCAR mag one..

what i was wondering was, should i just hammer / dremel it down ? but i don't think it is thick enough for dremel work its just a thin sheet of metel

does anyone else know of where to get the OEM polymer SCAR 17 mag followers?

 

[pupchow]

Anyone have any more recent info to add to this discussion?

 

[warwickben]

Better off not touching the follower since it aids in the way the mag stacks rounds