yup most likely close enough for sureHe took mine to the range and shot with his usual loads. Close enough, but I should check and re-do. Usually I just leave at my 200 zero.
If you enjoy the forum please consider supporting it by signing up for a NES Membership The benefits pay for the membership many times over.
yup most likely close enough for sureHe took mine to the range and shot with his usual loads. Close enough, but I should check and re-do. Usually I just leave at my 200 zero.
Im getting ready to drift my K31 sight. Need 2" correction at 100 yards. I hope to get one last test run out before sunday. K31 is aprox .006"= 1" at 100 yards.
Prepped the brass and hope to load tonight.
hammer and punch, someday I will make a sight pusher for the K31 ...sight pushes are great for on the line adjustments. At home I have a dial caliper so its pretty easy.A sight tool sure would be handy...
Nice I snuck out with 5 rounds for a quick k31 windage check after adjustment. Im going to give it another .008" drift and then it should be dead on or favoring the left a tad. i tend to drift to the right .Doing a LOT of projects around the house but took a couple hours to check the M1 w/ some ammo I had plus center the K31 windage.
Used a relatively light tack hammer with the punch and got the K31 nicely centered.
No idea how I shot that 10 in the black- maybe flinched. All shots should have been oriented to the 'ghost' rings. GP11. Might be hitting a little high for 200- we'll see.
If I have time and enough brass I may load up some 54R and try the M39.
What ammo? POA ? And what setting on the rear leaf at 100 yardsDoing a LOT of projects around the house but took a couple hours to check the M1 w/ some ammo I had plus center the K31 windage.
Used a relatively light tack hammer with the punch and got the K31 nicely centered.
No idea how I shot that 10 in the black- maybe flinched. All shots should have been oriented to the 'ghost' rings. GP11. Might be hitting a little high for 200- we'll see.
If I have time and enough brass I may load up some 54R and try the M39.
What ammo?
Playing with the EyePal thing.
It works pretty good . I tried making my own but could not get a clean cut on the hole. My only issue is its a bit hard to pick up the sights and target quickly.
Again my Rx lens still is not in. Next week sometime .... no one else seems anle to make me a lens for my RE Rangers.
In going to request to be between you and franco.But will it make it easy to pick up someone else's target quickly?
In going to request to be between you and franco.
When franco cross fires he generally tosses a 10! So I should come out even if I send one your way.
Pits are coming along , from what I heard waiting on a cement pour. ? Line is opened up already.
IF I show up I will be shooting my 1903a3 that I have been shooting cast loads in for years. This will be the first time I have run Jacketed ammo in this rifle for a long time. I ran out and did a quick Zero check and it shoots a tad high with jacketed ammo/ Running the Nosler 155s with 46 grains of H4895 for around 2600fps . I cant tell these days if its the load or my eyes but looks like 10 ring capable so good enough!
First shot went high? then it settled in ....under 3moa good for my eyes lately!
Which rifle/barrel?Seems that the cheap 155's tighten up a bit with a little more juice. First shot went very high- brass was pretty beat up on that case, plus I had just cleaned the chamber and bore:
First shot brass ejected at 1:00, next four at 4:00 as did the next ten shots. Guess I don't have to pitch those cheap bullets. Rest of my shots weren't as nice as the last four, but still GTG for the match.
Which rifle/barrel?
The 155s "palma" bullets , I think thats where the 155s came from? Seem to like to be pushed. Seems like 2600 fps is a zone that covers alot of ground from 110-175s