peterk123
NES Member
So I have been trying to adjust my full size die so I end up 1 to 2 thousandths headspace. But no matter how much I adjust the die I can't get there. I swear my shoulder is actually going in the wrong directing if anything. What could I be doing wrong?
This is an rcbs die on a hornady progressive. Is the shell plate the issue?
Is it possible that I'm not getting full expansion in the chamber with the first round shot out of the brass? I'm not getting consistent brass measurements before resizing.
This is an rcbs die on a hornady progressive. Is the shell plate the issue?
Is it possible that I'm not getting full expansion in the chamber with the first round shot out of the brass? I'm not getting consistent brass measurements before resizing.
Last edited: