Trying to get picture, but I left my phone at work...
Tried to get measurements with my micrometer and my battery died.
Setting up my new 550b with 9mm carbide dies and I have what appears to me to be a very noticeable "bell" to the casing after resizing... You can both feel it an see it. The top 2/3 is very consistent and the bottom 1/3 bells out and seems untouched by the die.
The die was tighten against the shell plate per dillon instructions....
Yes, I know 9mm is a tapered case, but this is a pretty defined "bell" at the bottom 1/3 of the case
Tried to get measurements with my micrometer and my battery died.
Setting up my new 550b with 9mm carbide dies and I have what appears to me to be a very noticeable "bell" to the casing after resizing... You can both feel it an see it. The top 2/3 is very consistent and the bottom 1/3 bells out and seems untouched by the die.
The die was tighten against the shell plate per dillon instructions....
Yes, I know 9mm is a tapered case, but this is a pretty defined "bell" at the bottom 1/3 of the case
Last edited: