If you enjoy the forum please consider supporting it by signing up for a NES Membership The benefits pay for the membership many times over.
Be sure to enter the NES/MFS May Giveaway ***Canik METE SFX***
Should this not go in the Gun Gallery section under December acquisitions? Just saying. Opinions may vary....Nice just the same.
That looks pretty real to my eyes. Where's the orange tip?
The EAA is probably one of the most comfortable designs for your strong hand.
Henning Tanfoglio Custom Parts has a lot of great parts for the EAA. Which is good because they guns break a lot if you use them constantly. I had to bring 2 to each match just to be able to finish
Yea already got some stuff from them!
Out of curiosity what is/has been breaking?
The factory sears/ hammers would round easily, causing hammer follow. I had sights break off. Slide stop pin break. Safety broke. frame peening.
I really wanted to like these guns, but I ended up getting rid of them after I replaced most parts with Hennings stuff
Do the steel frame ones also have heavy trigger slap out of the box? My poly framed 9mm did. It was annoying and my finger literally was sore after shooting 2 boxes through it. But it did eat up those 2 boxes of old ammo at the range right from the gun store, all I did was wipe the olive oil off it with some paper towel. Trigger job is real easy on this anyways (mix of pen spring and factory cz parts plus polishing), and some file work on the firing pin safety ramp on the slide gets rid of most of the trigger slap.