pastera
NES Member
Picked up an 80% in the last group buy just to see how hard it would be to finish.
Will be machining on a micro mill, as in 3/8 max endmill and 1/3 hp, so setup will be tight with a max Z of 8.5"
Step 1: make some vice plates to hold the lower
One down with the second blanked out.
Will be machining on a micro mill, as in 3/8 max endmill and 1/3 hp, so setup will be tight with a max Z of 8.5"
Step 1: make some vice plates to hold the lower
One down with the second blanked out.
Last edited: