I have been reading this forum for about 6 months and have been absolutely astounded by the wealth of knowledge contained within it. But, it finally happened, I have a question that I could not find the answer to.
I am attempting to remove the factory stock form a ruger 1022 international (this has a full length Mannlicher stock). what seemed like it should be an easy project has me stumped. I removed the take down screw. There does not seem to be a barrel band to remove. The receiver and barrel are locked in tight. I cannot get them to release from the stock.
Does anyone have any experience breaking down the 1022 with this type of stock. All of the manuals and diy pages that I found deal exclusive with the standard stock. I attached a couple pics to assist. There is a small hole under the tip of the barrel, but it doesnt seem to contain either a screw nor a pin.
Any assistance is appreciated.
I am attempting to remove the factory stock form a ruger 1022 international (this has a full length Mannlicher stock). what seemed like it should be an easy project has me stumped. I removed the take down screw. There does not seem to be a barrel band to remove. The receiver and barrel are locked in tight. I cannot get them to release from the stock.
Does anyone have any experience breaking down the 1022 with this type of stock. All of the manuals and diy pages that I found deal exclusive with the standard stock. I attached a couple pics to assist. There is a small hole under the tip of the barrel, but it doesnt seem to contain either a screw nor a pin.
Any assistance is appreciated.