Does anyone know where on line I might find an instruction sheet that explains the steps to field strip and re-assemble a Colt Mustang .380?
The retaining spring under the safety came out, and when I try to put it back together, I don't get a half-cock notch. If not that, the hammer slips off its spring. The ejector also slipped down into the grip where the magazine goes.
The gun was working fine, but then I tried to put a magazine in, and it wouldn't fit because of the ejector hanging down. I thought I could just push it back in place, but when I tried, I released the spring under the safety.
I hate to admit I can't figure this one out.
Can any of you help me out?
The retaining spring under the safety came out, and when I try to put it back together, I don't get a half-cock notch. If not that, the hammer slips off its spring. The ejector also slipped down into the grip where the magazine goes.
The gun was working fine, but then I tried to put a magazine in, and it wouldn't fit because of the ejector hanging down. I thought I could just push it back in place, but when I tried, I released the spring under the safety.
I hate to admit I can't figure this one out.
Can any of you help me out?