- Joined
- Feb 29, 2012
- Messages
- 13
- Likes
- 0
I received and installed my new apex sear yesterday (9mm M&P full size the sear is here). This is the first time ive taken a gun apart any further than a field strip, so i'll throw that out there first. I'm very mechanically inclined and after watching the video i knew i could do this on my own. I easily replaced the sear with in 10 minutes and had the gun put back together. To get the release the firing pin i need to pull the trigger all the way back and hold for a second or two and then you can hear the firing pin click. I tried this over and over with snap caps and its the same result. It seems as though the sear is machined too aggressively, but i've heard nothing negative about these. To trouble shoot i took the gun apart again and put my old factory sear back in and it worked just as it did before i put the new sear in. This tells me that i didn't bend or break anything in the install process. I then re-installed the new sear and the same problem comes up. As far as i can see, no parts of the gun seem to be modified. My questions are;
1. Has anyone had or heard of this issue?
2. I saw that the Apex site says that this works on current production models. I Bought this pistol used so im not sure how old it is. Is there any significant difference between, say the first production run and the newest one?
3. Any ideas on trouble shooting this while i wait for a response from Apex?
Thanks for the help...
1. Has anyone had or heard of this issue?
2. I saw that the Apex site says that this works on current production models. I Bought this pistol used so im not sure how old it is. Is there any significant difference between, say the first production run and the newest one?
3. Any ideas on trouble shooting this while i wait for a response from Apex?
Thanks for the help...