- Joined
- Nov 10, 2008
- Messages
- 7
- Likes
- 0
Picked this press up a couple of weeks ago, got my dies in yesterday. Well anyway followed all the set-up directions and resized around a dozen 223 cases everything fine to this point, then it got where it would not remove the primer.The die never moved it still touches the shell holder like before.Well I never seen anywhere how to adjust the decapping pin. I assume you just turn the nut on the top. I have another die on the way just for decapping due to the fact that most of the brass I have is crimped (Military) and just don't want to mess my die up pushing out crimped primers, thought maybe this may have played a roll in the decapping problem.Well my question is what would be the best way to make sure that it's adjusted right, cause it needs to go deep enough to decap but also deep enough so the ball resizes the neck all the way. I really don't think it ever went as far as it should have even when it decapped those first 10 or 12 just got lucky and caught it enough to pop the primers out. Let me hear some input from some of you reloading experts out there I'm always open for suggestions.
Thank's guys
makitaman60
Thank's guys
makitaman60