Delete please

[puška m70]

[

 

[snax]

Those should go in/out without needing a hammer. Trigger block usually first I believe

 

[Compooky]

Just wiggle the slide lock a bit and push the pin out since the lever is sitting in a groove.

 

[Rob Boudrie]

If you are using a hammer to install or remove Glock frame pins you are doing it wrong.

 

[Rob Boudrie]

Just wiggle the slide lock a bit and push the pin out since the lever is sitting in a groove.

Push from the left side or it will set in the other groove and you'll have to repeat the wiggiling.

 

[moojpg2]

Hold slide lock so it is out of the pin groove, push pin out from left side, should not require a lot of force. There should really be no hammer involved when working on a factory glock, you will mangle the hole in the slide lock lever hammering it like that, and eventually wear the groove down on the pin.

 

[EddieZoom]

Cleaning Glocks is considered back luck.....knock it off ;-)

 

[Jbarila]

View: https://m.youtube.com/watch?v=RcbzJBpZeo4