Smith & Wesson M&P9 in IDPA

Joined
Mar 9, 2008
Messages
70
Likes
0
Location
NH
Feedback: 0 / 0 / 0
Does the M&P series of pistols fall into the SSP or ESP category?

I'm weighing the pros and cons of the M&P vs the XDM. I've shot both the M&P and the orginal XD (not the M version), but I'm still up in the air about which to get.

Thanks.
 
You could shoot it in either SSP or ESP. Here are the requirements for SSP:

A. Be semi-automatic.
B. Be double action, double action only, or safe action (when
the trigger is pulled, the hammer/striker is cocked and then
released).
C. Be 9mm (9x19) or larger caliber.
D. Have a maximum unloaded weight of 39oz., including an
empty magazine. (Will be effective January 25, 2006)
E. Have a minimum annual production of 2000 units;
(discontinued models must have had a total production of
20,000 units).
F. Fit in the IDPA gun test box measuring 8 ¾” x 6” x 1 5/8”
with an empty magazine inserted.
G. Be loaded to the division capacity of ten (10) rounds in the
magazine plus one (1) round in the chamber. Should division
capacity not be achievable because of lower magazine
capacity, load to maximum mechanical capacity of magazine
plus one (1) round in the chamber. Competitors must use the
same capacity magazines through out the competition
20
(Example: if you start with a 9 round magazine, you must use
that capacity magazine throughout the match).
H. Begin hammer down for selective DA/SA pistols.
 
Yep. Got that, thanks.

I just wanted to verify that the M&P meets SSP criteria. As we know, the XD meets SSP criteria except for the trigger, which is ruled to be a single-action trigger. The M&P trigger feels better to me than the XD, which made me wonder if IDPA had ruled it as a single-action trigger, too.
 
Back
Top Bottom