Rockrivr1
NES Member
It's been a LONG time since I've installed a scope into a mount and I don't remember much about what I did. I now have a Leupold Mk4 LR/T scope that I'm about to install it into a LaRue LT-104 mount that will be used on my RRA LAR-8. (RRA's version of the AR-10)
My question is pretty simple. How much should I torque down on the mount screws to keep the 30mm tube stationary? Also, could I torque it to much and damage the tube? Just trying to figure out how much I should tighten the screws down.
Thanks
My question is pretty simple. How much should I torque down on the mount screws to keep the 30mm tube stationary? Also, could I torque it to much and damage the tube? Just trying to figure out how much I should tighten the screws down.
Thanks