I just got a set of Lee 41 mag dies. I set them up all up with no problem except for the sizing/depriming die.
I followed the instructions for putting it in press, a Hornady LNL AP and I used a Hornaday bushing.
Trying to twist the top to extend the decapping pin is impossibile with my fingers. So I tried using two wrenches like the instructions say and the pin still won't move.
Can any one tell me what I'm doing wrong?
I followed the instructions for putting it in press, a Hornady LNL AP and I used a Hornaday bushing.
Trying to twist the top to extend the decapping pin is impossibile with my fingers. So I tried using two wrenches like the instructions say and the pin still won't move.
Can any one tell me what I'm doing wrong?
Last edited: