Ok so I f***ed up. I was changing my trigger guard on my ar15 when stupid me I used a punch that was a bit to big and broke off one of the ears that hold on the guard. I know it is a cast reciever but can it be welded or fixed somehow someway and then painted again or is it more economical to buy a new lower
-
If you enjoy the forum please consider supporting it by signing up for a NES Membership The benefits pay for the membership many times over.
-
Be sure to enter the NES/MFS May Giveaway ***Canik METE SFX***
Gunsmith question
- Thread starter Jess02053
- Start date
Remsport Mfg
NES Member
Most likely it is a forged receiver and it could be TIG welded, however it would most likely by the time you got done it would cost you almost as much as it would be to replace.
We currently have our lower receivers on sale for $109.00 and if you pick up at Remsport there is no transfer fee.
We will also be at the Marlboro show this week end.
We may have some show speciales on ATR lower receivers.
Thank you
John
413 579 1994 contact us.
We currently have our lower receivers on sale for $109.00 and if you pick up at Remsport there is no transfer fee.
We will also be at the Marlboro show this week end.
We may have some show speciales on ATR lower receivers.
Thank you
John
413 579 1994 contact us.
