I wasn't sure if I should put this here or in general but here goes... Anyone here use a electric sharpener? I would post a link but I am an idiot when it comes to computers if my wife isn't here to show me how. Lol probably one of the only 32 y/o males out there saying that but hey I am a carpenter and don't need no stinking computer. But I am talking about one of the bench mount ones not the handheld "dremel" type. I cut a lot of firewood for me and my mother and do a decent amount of land clearing type stuff around my small farm (23 acres). Well I was noticing yesterday that I am getting a good pile of chains in the garage that need a good sharpening. The guy that lived here before me nailed a lot of fence to trees and stuff so when I am cutting and find one of his old staples I generally just throw a new chain on because its too much work to file it out evenly around the whole chain by hand. I know my local shop will do it but its easier to just buy a new chain than drive there and back twice to drop off and pick up (cost of gas) plus the sharpening. So I got to thinking about a sharpener. I have seen them at Tractor Supply and such for around a hundred bucks or less. I have 3 saws and one of them has 2 different bar sizes so I have 44 different length chains with 3 different tooth sizes that need to be done. Thanks for any suggestions.