• If you enjoy the forum please consider supporting it by signing up for a NES Membership  The benefits pay for the membership many times over.

Any one got hk jig?

new guy

NES Member
Rating - 100%
64   0   0
Joined
Dec 7, 2009
Messages
26,457
Likes
27,917
I saw one forum where someone was talking about being able to buy the prints on gunbroker for $13, but it was from years ago. They're out there...
 

Wildweasel

NES Member
Rating - 100%
37   0   0
Joined
Feb 26, 2005
Messages
1,617
Likes
222
Location
Western MA
when I did mine I used the old screw a rod to the bench and bend with screwdrivers then 2 pieces of angle iron on each side of the top piece and my press. worked ok on one.
 

cetme24

NES Member
Rating - 100%
9   0   0
Joined
Sep 18, 2012
Messages
161
Likes
186
Location
Carver
No jig but I have a century cetme. I can take some measurements off it if you need. It seems a lot of build info for many guns that was once available does not exist anymore.
 

AKMS

Banned
Rating - 100%
1   0   0
Joined
Sep 12, 2016
Messages
126
Likes
51
Location
Copp's Hill
I've seen a thread about using galvanized pipe. Having used a "official" jig under incorrect guidance from its owner, the pipe would have been more effective.
 
Top Bottom