Any one got hk jig?

I saw one forum where someone was talking about being able to buy the prints on gunbroker for $13, but it was from years ago. They're out there...
 
when I did mine I used the old screw a rod to the bench and bend with screwdrivers then 2 pieces of angle iron on each side of the top piece and my press. worked ok on one.
 
No jig but I have a century cetme. I can take some measurements off it if you need. It seems a lot of build info for many guns that was once available does not exist anymore.
 
I've seen a thread about using galvanized pipe. Having used a "official" jig under incorrect guidance from its owner, the pipe would have been more effective.
 
Back
Top Bottom