If you enjoy the forum please consider supporting it by signing up for a NES Membership The benefits pay for the membership many times over.
Be sure to enter the NES/MFS June Giveaway ***Keltec SUB2000***
Thanks to everyone that came out to the match. And thanks to everyone that helped build the stages and RO.
I hope everyone enjoyed the stages.
Sorry about the classifier, It was set up significantly closer than it should have been and would not have been accurate.
From which I infer that it was thrown out.
Works for me - the ONE gun hiccup (probably a slightly light load) occurred on that stage. Hard to make up on a 12-shot stage.....
The large popper placement on Range 1 also had some issues, but it's too late now....
Thanks for all your work at AFS this season.
The name was slightly changes ("Six Targets" rather than "Six Chickens") on the results to avoid confusion.Stage 4 wasn't thrown out, it just was not submitted to USPSA, but will count for the match
There are few problems that can't be solved without duct tape, including marking the floors without the use of paint (AFS as asked that we not leave any permanent markings on the floor). I'll try to remember to bring a roll to the first match with the next winter season starts.Yeah its tough to stake down the poppers on the concrete floor
Congrats to the Open Division winner, Alan Waterman. He shot his first USPSA match last September. I'm looking over my shoulder.........................
Yeah its tough to stake down the poppers on the concrete floor. Each squad knew that they need to be in a line as they bounce around when they land. unfortunately it doesn't always happen when they get reset
I'm trying to make the matches more real life, my steel shoots back.... take that IDPA
Even in a USPSA thread for a match you just can't resist can you? May I ask what happened to you today? You should have borrowed my Glock.
I can't resist, I won't resist
I do find an indoor range makes it easier to find all the piece to a glock after you pull the [STRIKE]pin[/STRIKE] trigger
My gun was having issues with hammer follow caused by the disconnect notch. Then it started jamming. Sat match, the dot dies on my gun, point shot the match.... overall not a good weekend of shooting
I did find some 38 Super brass that doesn't feed well in my Glocks.
What, wasn't it bulged enough?
Since you are such an advocate of the Lee FCD, I've jumped in too. No bulged brass for me.
Thanks to everyone that came out to the match. And thanks to everyone that helped build the stages and RO.
I hope everyone enjoyed the stages.
Sorry about the classifier, It was set up significantly closer than it should have been and would not have been accurate.
Scores are up
http://uspsa-ne.org/results/20100328_afs.txt