Hey all,
After setting up the die to spec, I sized/primed some LC 5.56 brass in order to have it set up for easy completion down the line. I decided to re-measure the brass with my RCBS precision mic, and somehow the headspace is around -.005 to -0.007 or so. (the mic dials back to 45-43 past zero). With this being loaded for an AR, is this still ok to use, or have I bumped it back too far? And if I have bumped it back too far, what are my options?
I *did* check some of the more extreme ones in a wilson case gauge and they appeared to be within the bottom threshold, but wanted to make sure I'm still ok.
Thanks!
After setting up the die to spec, I sized/primed some LC 5.56 brass in order to have it set up for easy completion down the line. I decided to re-measure the brass with my RCBS precision mic, and somehow the headspace is around -.005 to -0.007 or so. (the mic dials back to 45-43 past zero). With this being loaded for an AR, is this still ok to use, or have I bumped it back too far? And if I have bumped it back too far, what are my options?
I *did* check some of the more extreme ones in a wilson case gauge and they appeared to be within the bottom threshold, but wanted to make sure I'm still ok.
Thanks!