basscatfrank
NES Member
I started moving my guns into the safe I received for Christmas. I love the new safe, the only drawback I see is something I know someone here must have figured out by now. That is what to do with guns that don't quite reach the holes in the shelf that the barrels rest in. I have two ideas. One is to screw together a couple of 2X6's, carpet them, and rest the butts on it. The other idea is to get some foam and glue it to the underside of the shelf which would allow the barrels to reach. What have you done to alleviate this problem?
On a side note, I added lighting to my safe as well. I went to Home Depot and purchased an 18 foot length of LED rope light. It is enough to go from the floor and up the hinge side of the front, along the top side to the back, and then along the other side and down to the floor again on the other side of the safe. Forty bucks for the light and $3 for the switch. Looks pretty good if I do say so myself. Almost forgot, I installed my Goldenrod as well.
On a side note, I added lighting to my safe as well. I went to Home Depot and purchased an 18 foot length of LED rope light. It is enough to go from the floor and up the hinge side of the front, along the top side to the back, and then along the other side and down to the floor again on the other side of the safe. Forty bucks for the light and $3 for the switch. Looks pretty good if I do say so myself. Almost forgot, I installed my Goldenrod as well.