If you enjoy the forum please consider supporting it by signing up for a NES Membership The benefits pay for the membership many times over.
Be sure to enter the NES/MFS May Giveaway ***Canik METE SFX***
I have a Hornady bullet puller, it works very well, much better than the hammer type. Its alot faster and cleaner
http://www.midwayusa.com/eproductpage.exe/showproduct?saleitemid=851547&t=11082005
Do they have 10mm?
That's 10.41 mm, it might work but you'd have to muscle it to get each bullet out of the collet, which is a pain.
10mm=.400
so wouldnt the collet not hold the bullet
Not to be a ball-buster but in my line of work with you showing a three place decimal, you would be out of tolerance.
10mm = .393 or .393700787etc
Not to be a ball-buster but in my line of work with you showing a three place decimal, you would be out of tolerance.
10mm = .393 or .393700787etc
I have a Hornady bullet puller, it works very well, much better than the hammer type. Its a lot faster and cleaner
What are you using for a press?
I use one of those hammer jobs with the adjustable ring thing in it.
It's not as elegant as a press mounted puller, but I look at it this way... it's a built in incentive to screw up less.
-Mike
Will the collet type puller distort the bullet? Just wondering.
It will leave a slight ring where the collet grabed the bullet.Will the collet type puller distort the bullet? Just wondering.