Hello, I have done a lot of searching, read a lot of posts, but just cannot get a clear answer. I would be very grateful if someone could point me in the right direction here. I load a lot of pistol calibers and shotgun, not so much rifle.
Getting started and I want to reload my .223 brass and 5.56 brass and don't want to have to care which is in the press (once properly processed). Can I use starting/non-max .223 data in my 5.56 cases? Or does the restricted internal case volume of the 5.56 demand an even lower load.
Thank you
Getting started and I want to reload my .223 brass and 5.56 brass and don't want to have to care which is in the press (once properly processed). Can I use starting/non-max .223 data in my 5.56 cases? Or does the restricted internal case volume of the 5.56 demand an even lower load.
Thank you