Wanted Machinist in plymouth area for a barrel M1 garand trim and recrown

[mac1911]

I have a LMR 1955 M1 garand barrel that I would like to cut the muzzle back a bit and cut a new crown...maybe 11' target crown.
Anyone out there want to give it a try. The barrel is off the receiver.

Right now the muzzle reads 2+ on the MW gauge and I would like to see the barrel cut back a bit and see how much the guage may improve. Then cut a target crown...

 

[whalerman69]

Try Gartman Guns rt 1 wrentham

 

[mac1911]

Try Gartman Guns rt 1 wrentham

Im really trying to find someone close..

 

[mac1911]

up for another try

 

[DW357]

What about Dave Santurri in Attleboro? He cut and recrowned my Mosin barrel a few years ago.

 

[Shawnyc]

I know someone in Acushnet MA although I'm not sure if he is taking on any work. If your interested PM me and I'll find out. I have had a good amount of work done through him and zero complaints.

 

[KBCraig]

Are you sure you don't want it counterbored, to keep the OAL the same?

 

[mac1911]

Are you sure you don't want it counterbored, to keep the OAL the same?

nah don't care about that, barrel is a bit rough its just a little experiment. figure if im reading my muzzle gauge right chop off 1/8" and recrown only the garand guys with a good eye will catch the shortness

 

[mac1911]

What about Dave Santurri in Attleboro? He cut and recrowned my Mosin barrel a few years ago.

I want someone close, like with in 15 min

 

[jtnf]

I want someone close, like with in 15 min

Does Franco have the ability to crown a barrel?

 

[mac1911]

Does Franco have the ability to crown a barrel?

I think he has the on rifle crown tool.
I want to chuck it up and cut the barrel back about 1/8" and recrown it. I might just sell the barrels as is?