Palladin
NES Member
I have the basic Stack-on safe...16 position. The barrel supports are set for shotguns/rifles with at least a 24" barrel. Most of the long guns I have are carbine configuration...10/22, AR, AK, etc.
The supports are screwed into a bracket factory welded to the safe. In order to lower the bracket, should I simply drill a hole thru the rear of the safe and lower the supports?
Any ideas?
The supports are screwed into a bracket factory welded to the safe. In order to lower the bracket, should I simply drill a hole thru the rear of the safe and lower the supports?
Any ideas?