Ruger Mark IV Screws

[Silverado]

Looking to remove the three barrel receiver filler screws. They look to be hex or torx but they are not flat tip. I've search just about everywhere on what size allen or torx wrench. I've came up with sizes for the sights but not the barrel receiver

 

[JRT]

Looking to remove the three barrel receiver filler screws. They look to be hex or torx but they are not flat tip. I've search just about everywhere on what size allen or torx wrench. I've came up with sizes for the sights but not the barrel receiver

T-10

Point of clarification. Is this where you would mount a rail? I want to be sure we are talking the same thing.

 

[Silverado]

T-10

Point of clarification. Is this where you would mount a rail? I want to be sure we are talking the same thing.

Yes the barrel receiver and thanks

 

[Silverado]

Found my set of small torxs and as it turned out it was a T-6 for the three screws, the front sight might be a T-10. In any case they all back out easy.

 

[JRT]

Found my set of small torxs and as it turned out it was a T-6 for the three screws, the front sight might be a T-10. In any case they all back out easy.

All of mine including the rear site are T-10. Mine is the lite with the rail.