Question on Model Seven checkering

Joined
May 14, 2021
Messages
18
Likes
20
Feedback: 0 / 0 / 0
I'm needing a new stock for a Rem Model Seven.

Looking in to it, apparently Rem offers the laminated stock with both "regular" checkering, and "laser cut" checkering.

The pictures look the same. Does anybody know the difference (if any)?

Thanks!
 
Personally like hand cut better because you can tell it is hand cut, there is always an error, a tiny run over, a narrow line that the next line follows or is cut deeper or shallower than the next, always some imperfection here or there even in the best most expensive custom hand checkering. Laser checkering is too perfect in the layout, line straightness and so consistently even that it is cookie cutter checkering. That said todays factory lazer checkering is so much nicer than that horrible stamped checkering of the 60's to 80's.. Stolen from the net....:)
 
Personally like hand cut better because you can tell it is hand cut, there is always an error, a tiny run over, a narrow line that the next line follows or is cut deeper or shallower than the next, always some imperfection here or there even in the best most expensive custom hand checkering. Laser checkering is too perfect in the layout, line straightness and so consistently even that it is cookie cutter checkering. That said todays factory lazer checkering is so much nicer than that horrible stamped checkering of the 60's to 80's.. Stolen from the net....:)
Thanks for your input
 
Back
Top Bottom