I was at the range using a 625 with moon clips when the cylinder locked up. I got it open and dropped the moon clip out and noticed that a primer was missing in a unfired round. I'm postive that the rounds all had a primer in them when I started.
When I reload I take all the rounds and inspect them as I put them in to 100 round boxes and then before I put the box away, I look at the primers again to make sure their seated properly.
This has never happened to me before, so I was a little surprised that this happened. I was using 4.3grs of Red Dot with 200gr cast with Wolf large primers which isn't a very hot load.
Has any one else ever have this happen?
When I reload I take all the rounds and inspect them as I put them in to 100 round boxes and then before I put the box away, I look at the primers again to make sure their seated properly.
This has never happened to me before, so I was a little surprised that this happened. I was using 4.3grs of Red Dot with 200gr cast with Wolf large primers which isn't a very hot load.
Has any one else ever have this happen?