primed brass

wjsmall97

NES Member
Joined
Aug 22, 2009
Messages
1,061
Likes
287
Location
S.E, N.H.
Feedback: 1 / 0 / 0
Does anyone size primed brass? I purchased 100 primed Nosler brass from American Reloader (.260 Rem), and I am wondering
about running them through my dies. Should I just remove the decapping pin, just resize the case mouth, or pop out the primer.
They are " demilitized brass " where they were loaded rounds for the government ( I believe ) and they pulled the bullets and sell the pulled bullets and the primed brass.
Thanks, Bill
 
The biggest concern is getting case lube in the primer.

Otherwise, go for it.

But…. Are you sure you need to resize? Presumably they were sized before the bullets were pulled.
 
Jumping on the bandwagon for pulling the decapping pin.
If you are worried about the lube residue clean the necks out with q-tips
 
The biggest concern is getting case lube in the primer.

Otherwise, go for it.

But…. Are you sure you need to resize? Presumably they were sized before the bullets were pulled.
One shot does bot affect primers.
Also, with 100 cases he could carefuly lube the outside of each case.

OP, I say go ahead and do it.

I just ordered from GB 100 reloaded rounds of 357 Dan Wesson. Reloader unknown, but I need the brass so I will pull all the bullets, keep the primers and run through sizer.
 
Back
Top Bottom