If you enjoy the forum please consider supporting it by signing up for a NES Membership The benefits pay for the membership many times over.
Be sure to enter the NES/MFS February Giveaway ***Taurus G3***
Anyone offer this service around here or would that be something I’d have to ship out I wanna do something on my AR lower wondering if I can go local. Thank you
Several years ago I used Jack’s Machine Shop. It looks like they go by South Shore Manufacturing now. They are located in Hanson.Anyone around the south shore?
+1. I had an AR lower engraced by Eddie Coyle and it was while you wait and flawless. He managed to fit it on the small flat beven on a traditional AR lower - Crisp, straight, even. Much nicer than the "Very Nice" in the image below.+1, he's done a few NFA engravings for me. Good guy.
I drove down to get my NFA engraving done at Jack’s cause The Mill didn’t take off yet at the time. My brother drove his to Jacks from Hollis.Several years ago I used Jack’s Machine Shop. It looks like they go by South Shore Manufacturing now. They are located in Hanson.
South Shore Manufacturing (formerly's Jack's Machine Co.) has the experience and knowledge to handle your most technical and challenging machining jobs.www.southshoremanufacturing.com