So, I just picked up a KelTec Sub2000 multimag, put in the Sig mag catch, and tried to run Ramline P226 pre-ban mags in it. Unfortunately the slot for the mag catch on the Ramline is too narrow and the catch won't, well, catch. I either need to carefully widen the slot with a dremel or similar, or re-sell the mags. Anyone have experience cutting a mag catch slot? Any recommendations?
-
If you enjoy the forum please consider supporting it by signing up for a NES Membership The benefits pay for the membership many times over.
KelTec Sub2000 with Ramline Mags
- Thread starter jbos6
- Start date
Rocky Mosasaurus
NES Member
DIY USA Glock 17 Magazine Modification
Dear NES community members, I recently went to the range and had a problem with my USA brand G17 18 round magazines. They have a lip at the front of the base plate that juts out into the mag well. At one time this lip may have been soft and malleable...but over time the lip hardened and it will...
www.northeastshooters.com
See similar content here on this thread. One person recommended using a Dremel over the tool I used, which was a soldering knife. I recommend using a Dremel then filing it down afterwards.
