HELP! cant get a A1 AR-15 rifle length buffer tube off

[ArmySGTPM]

Trying to change out an A1 stock for a collapsable stock for my friend... I have never seen a buffer tube stuck so tight!!! the metal on the end actually tore away as I was attempting to break it loose using an adjustable wrench. ANY IDEAS?!

thanks


pete

 

[MotorHead]

First, you need an AR stock removal tool. Then, put some heat to it. Most likely has Lock-tite on it. Start with a hair dryer - be careful nothing plastic melts. If it does not work, CAREFULLY work your way up to a heat gun with a controlled nozzle. Again, make sure nothing other than Lock-tite is melting. Last suggestion is a pinpoint gas torch available at big box stores. But before you go further, get an AR stock removal tool.
Good luck.

 

[ArmySGTPM]

Thanks! I guess i cant get this done tonight.... i've never felt one that is sooo tight.... leave it to the state police haha

i didn't realize he had a A1 tube on it till i got it tonight... oh well

I could always cut it !! haha

its a nice looking gun I will upload a pic in a minute

 

[ArmySGTPM]

 

[vellnueve]

Hate to point out the obvious, but all full-length tubes are A1 tubes.