- Joined
- Oct 31, 2020
- Messages
- 1,610
- Likes
- 1,886
I have a brand new bag of 6.5CM brass and would like to fireform it to my rifle. This is the first time I've bought brass. Previously, I would buy a few boxes of factory ammo and reuse the brass. Factory brass is typically loaded to the max but I usually load a little lower(use the trick where I increase until I see signs of pressure then back off by 0.1gr until groups stop shrinking in size)
My question is: is there a general consensus as to how much powder to use for fireforming? Min? Max? Same as the load I plan to use?
My question is: is there a general consensus as to how much powder to use for fireforming? Min? Max? Same as the load I plan to use?
Last edited: