Find-a-pro on NES

SteelShooter

NES Member
Rating - 100%
31   0   0
Joined
Jan 4, 2009
Messages
9,152
Likes
2,320
Location
MA
Need a Tree Guy near Lynn. I have a 60' 30" diameter maple tree that was damaged in the last wind storm I want to have taken down. No debris or limb take away (unless you want to), but will need it cut into manageable sections. Might be able to get a bucket truck in, 12' wide driveway.
 

twolane

NES Member
Rating - 100%
1   0   0
Joined
Jan 27, 2010
Messages
18
Likes
17
Looking for powder coating in the southern Mass / Providence area.
Recommendations/ suggestions would be great.
Thanks!
 
Rating - 100%
1   0   0
Joined
Jan 20, 2013
Messages
107
Likes
12
Just bought a house in Waltham. Looking for somebody to renovate 1.5 bathrooms, kitchen, and build a 30 x 30 attached garage.

Also looking for an HVAC installer.

Also looking for a designer/architect.
 

Terrys

NES Member
Rating - 100%
3   0   0
Joined
Nov 8, 2011
Messages
765
Likes
207
Location
Cape Cod, MA
I’m looking for an electrician on Cape Cod (mid-Cape area) to replace a 30+ year old 100 amp GE circuit breaker panel. Cracked main breakers.
 

andrew1220

NES Member
Rating - 100%
121   0   0
Joined
Oct 2, 2011
Messages
13,839
Likes
7,938
Location
North Shore

zboys

NES Member
Rating - 100%
8   0   0
Joined
Jan 30, 2017
Messages
1,461
Likes
1,880
Location
N. Central MA

andrew1220

NES Member
Rating - 100%
121   0   0
Joined
Oct 2, 2011
Messages
13,839
Likes
7,938
Location
North Shore
Call a local oil company, or else plan to get raped severely.
I've changed 3 in the past month, average cost, $2200.
Good call. I'm paranoid mine is going to leak/release at some point since it's freakin old. House was built in 1935 but it used coal for a little while so I'm guessing the tank is from the 40s maybe 50s.
 

daggrant99

NES Member
Rating - 100%
2   0   0
Joined
May 23, 2014
Messages
328
Likes
181
Thanks for the info, the property is in Dorchester, got a quote from "Tanks a Lot" for $2200. 2 local oil guys said to call them.
 

chris_1001

NES Member
Rating - 100%
28   0   0
Joined
Dec 3, 2008
Messages
3,560
Likes
1,140
Location
MA
Rear brake pad swap in/around Franklin?

I did the fronts a few months ago,, did not have the time to do the rear, I have the OEM Toyota rear pads.

Still no time to do them, wanted to see if anyone had a connection or recommendation in or around Franklin who could swap out the pads. Rotors are fine.

2016 Toyota 4Runner

Thanks, Chris
 

TrackDayRdr

NES Member
Rating - 100%
1   0   0
Joined
Jan 13, 2019
Messages
370
Likes
326
Location
North of Boston, MA
I'm in a condo (built in 2009) with forced hot air. System is working fine but I only get a trickle of air from the ceiling ducts. My HVAC guy said he thinks the trunk (attached to the furnace) is the problem. It does seem small, with lots of branches but what to I know? I'm hoping someone on here knows about this stuff and can fix this. Condo is in Wilmington, MA.
 

TrackDayRdr

NES Member
Rating - 100%
1   0   0
Joined
Jan 13, 2019
Messages
370
Likes
326
Location
North of Boston, MA
If it's working fine, there's prob. not a problem, it should not blow with much force
I'm just comparing it to other places where the curtains move or you can feel the air move when the heat comes on. There is also a leak in the trunk that inflates the foil bubble wrap jacket. I spent an hour looking for that last night but no luck. I was also told that the transition from the furnace to the trunk is too short and the air is hitting a wall and probably not pressurizing the system enough to flow air.
 

mac1911

NES Member
Rating - 100%
69   0   0
Joined
Dec 26, 2008
Messages
30,099
Likes
7,743
This section would work better and be easier to scan through if you could add titles to the posts?
That said
Looking for builder/contractor for basement over haul/redo
Floors to ceilings , plumbing , electrical over haul.
 
Rating - 100%
3   0   0
Joined
Sep 15, 2017
Messages
340
Likes
228
Just bought a house in Waltham. Looking for somebody to renovate 1.5 bathrooms, kitchen, and build a 30 x 30 attached garage.

Also looking for an HVAC installer.

Also looking for a designer/architect.

If you still need someone, send me a message, im an Architect.
 

Keeper

NES Member
Rating - 100%
24   0   0
Joined
Jan 10, 2013
Messages
755
Likes
194
Location
North of Boston
Looking for gas furnace service and duct work near Chelmsford. Noticed a lot of air blowing into the basement, filter is a pain to replace, and furnace needs servicing.
Also, interested in ductless wall mount ac for a top floor room where I can no longer stand the noise from my unit.
 

daveyburt

NES Member
Rating - 100%
15   0   0
Joined
Jan 2, 2010
Messages
2,177
Likes
843
 

citoriguy

NES Member
Rating - 100%
29   0   0
Joined
Dec 14, 2018
Messages
2,699
Likes
2,001
Location
PRM
I need a contractor in the Maynard/Acton/Concord area. I have a leak coming through where a skylight is and need help assessing the extent of the damage and then putting in a plan of action.

Please PM me if you’re able to help or can recommend someone who can. Happy to trade business and/or personal income tax work/consulting. Happy to pay as well.
 

Len-2A Training

Instructor
Instructor
NES Life Member
NES Member
Rating - 98.4%
61   1   0
Joined
Feb 26, 2005
Messages
52,480
Likes
10,736
Location
Escaping to NH
Anyone have a plasterer they would recommend around Norton/Attleboro?
Absolutely.

RJB Plastering
Robert "Judd" Bongo
[email protected]
(508) 380-1514
He operates out of Mansfield.

He's a member of Mansfield F&G and works on word-of-mouth advertising. After PIC Home Pros (Londonderry NH) cracked every ceiling in my house and bailed on repairing the damage, I hired Judd to replace/plaster our ceilings. His helpers are all relatives and they did a great job. I highly recommend him. He was recommended to me by my carpenter who is a BOD member at MF&G.
 

GaryO

NES Member
Rating - 100%
17   0   0
Joined
Aug 15, 2006
Messages
12,735
Likes
5,057
Location
Franklin
Any carpenter recommendations in the Franklin area? Need a set of stairs built on the outside of my house.
 

daveyburt

NES Member
Rating - 100%
15   0   0
Joined
Jan 2, 2010
Messages
2,177
Likes
843
Looking for chimney inspection - shrewsbury.
Original build, brick, clay flue.
Two flu's to be looked at.
 

GomerPile

NES Member
Rating - 100%
13   0   0
Joined
Nov 18, 2008
Messages
4,666
Likes
2,092
We are getting ready to start back up at my place. Many customers are asking for good quality (professional) masks for business. Here are some samples we sent out yesterday and today. Based on the reactions we have gotten (lots of referrals), I think custom masks are going to be very popular. PM me if you need anything. We're still a week or so from having them up on the web site, but we are taking offline orders starting today. This style (made in USA BTW) comes in 14 colors and is a 3 ply cotton fabric.

IMG_0025 2.JPGIMG_0513.JPGIMG_0507.JPGIMG_0501 2.JPG
 

RB101

NES Member
Rating - 100%
16   0   0
Joined
Apr 22, 2008
Messages
572
Likes
50
Location
Central Mass
Looking for a deck guy. South central MA. Deck is stripped and prepped, just need someone good with composite and hidden fastener system. A days work for someone that’s done it before. Cash....
 
Top Bottom