I was looking in my bullet tray last night and noticed I've been spilling powder here and there from my RCBS Uniflow powder measure. I've been using the smaller of the two powder drop inserts and have been using lite pressure upwards with my primed cases into the mouth of the drop, but am inevitably still experiencing some spillage. Is there any way to control this other than trying to wedge a giant funnel into each case prior to dropping a charge?
I know this is going to effect my chrono readings when I finally get to shoot the ammo I made, I'm just wondering by how much and if I should really just pull the bullets and reload the cases or just shoot them (obviously checking for pressure signs along the way)...none of the charges were maxed out to begin with, so if anything I'll have slightly undercharged rounds.
I know this is going to effect my chrono readings when I finally get to shoot the ammo I made, I'm just wondering by how much and if I should really just pull the bullets and reload the cases or just shoot them (obviously checking for pressure signs along the way)...none of the charges were maxed out to begin with, so if anything I'll have slightly undercharged rounds.