AR10 in 308 charging handle recommendations needed

[Gator9329]

I'm putting together a new upper for my AR10 lower. I've sourced most the parts to build a bench rest focused setup. I have a JP rifle barrel,hand guard, BCG+bolt on one of their uppers. The stock will be a Magpul PRS.
I am going to be putting a scope on it. Not sure what one it will be .
Looking for recommendations for a ambi charging handle. The one on my current upper is a no name . It does the job, but I would like something a little better than an airsoft piece.
Looking to you guys for recommendations on what you have used.
Thanks

 

[jayhitek]

Can't go wrong with the Radian Raptor

 

[Queen Bee]

Radian raptor gets my vote for ambi. If going non ambi like i am for my 6.5 build, go PRI gasbuster

 

[Machete]

I've been running the BCM mod4 on my .308.

 

[Gator9329]

Cool , Thanks for the input.
Looks like I am going full size raptor. Should fit in well with what I need

 

[citoriguy]

I had a Strike Industries CH that was a one-sided release that I eventually switched out for a Geiselle Airborne CH which is the ambi-pull CH. I really prefer that to the SI. I'm only holding on to it in the off chance I build a 6.5CM upper at some point down the line.

 

[warwickben]

man up and just make it side charging your self. mill slot, spot bolt. drill tap done. the meat ball tony we did his in under a hour.

 

[Sunny]

Another vote for Strike Industries. They make one with a polymer latch so it doesn’t damage the upper. Pretty cool.