allen-1
NES Member
I guess this could go in the ammo or pistol competition forum, but it seemed appropriate to post it here...
I shoot what's termed as "medium bore" pin league, (well I would be if it weren't cancelled from the fcking virus). Anyhow, medium bore is defined as less than .40 and no magnum. So, I shoot 9mm in the semi-auto division and .38 spcl in a GP100 in the revolver division.
Normally I shoot 125 -> 135 grn rounds in the revolver, for pins I run 158.
For my semi, I've been running the same rounds I normally load, 124 grn plated, (Xtreme or Berrys), over 4.0 grn of TiteGroup. It's a nice consistent round, manageable recoil, minimal blast (I mean seriously - it's a 9mm - how rough could it be?), and it knocks steel down reliably.
I have some 147grn Speers bullets left from the batch of .357Sig I loaded. I'm thinking of making a pin load out of them, and wondered if anyone here had any thoughts.
I shoot what's termed as "medium bore" pin league, (well I would be if it weren't cancelled from the fcking virus). Anyhow, medium bore is defined as less than .40 and no magnum. So, I shoot 9mm in the semi-auto division and .38 spcl in a GP100 in the revolver division.
Normally I shoot 125 -> 135 grn rounds in the revolver, for pins I run 158.
For my semi, I've been running the same rounds I normally load, 124 grn plated, (Xtreme or Berrys), over 4.0 grn of TiteGroup. It's a nice consistent round, manageable recoil, minimal blast (I mean seriously - it's a 9mm - how rough could it be?), and it knocks steel down reliably.
I have some 147grn Speers bullets left from the batch of .357Sig I loaded. I'm thinking of making a pin load out of them, and wondered if anyone here had any thoughts.