Search results for query: *

  1. Spring size for magazine extensions

    Depends on how many rounds you are adding. If +2 stock spring is usually enough. To make sure, I always use Wolff +10% springs and have never had an issue. If adding more than 2 rounds, check with the company you are buying the base pads from and see what they recommend.
  2. 147 vs 125

    Want to try some Bullets Brian? I have 135, 147, and 160gr sitting in the cellar. Let me know
  3. NES/MFS March Gun Giveaway

  4. Our Oil Burner (home) Motor Problem (video) .. Any "experts" here?

    Replace the control. R8184G 4009 Should stop the issue. You can hear it dropping out. If it was the pump coupler the motor would continue to run but the flame would drop out. When you change the control, change one wire or set of wires at a time to prevent screwing it up
  5. Bourne Bridge Guns and Ammo

    Speedway gas and Dinks now
  6. NES/MFS August Giveaway

  7. Local (NH) sources for bulk meat for dog food?

    I use Honest Kitchen Dehydrated Raw supplemented with raw from Dogs Gone Raw. Raw Dog Food - New England | Dogs Gone Raw I believe he has a delivery to NH With a Corgi, there is not as much needed
  8. Pachmayr Box Help

    Sold mine too
  9. Pachmayr Box Help

    Looking at this more closely and comparing to one on EBAY, someone added wood spacers to the wood surfaces between each position. Probably had light barrel guns. Look at this picture...
  10. Pachmayr Box Help

    Slide the 1911 back so you are clamping closer to the end of the slide
  11. Aftermarket Ruger mark III trigger,, which one is best for bullseye?

    Don't remember for sure but I believe Gallery rules are no less than 2# trigger so be careful. There is always "That Guy" with a set of weights. The Volquartsen internals are great but also take a good look at the Tendemkross trigger. Have one on my 22/45 and like it a lot
  12. Slipped a disk in my back (i think?)

    Ruptured a disc in my 30s. With exercise and a very good chiropractor, I was OK until my early 60s. I did heavy work but working bent over is what finally did me in. Chiropractor could no longer give me relief and advised me to get a MRI. Diagnosis was Spinal Stinosis. In Dec 2012 I had...
Top Bottom