• If you enjoy the forum please consider supporting it by signing up for a NES Membership  The benefits pay for the membership many times over.

Recent content by LuvToGoFast

  1. Red dot on SD9VE

    Thank you everyone. I think I have my answer.
  2. Red dot on SD9VE

    Has anyone mounted a red dot on a SD9VE? If so, what are my options? Mounting plate vs having a smith mill it? I may buy something optics ready but this is what I have at the moment and I want to know my options. Michael
  3. Any docs?

    View: https://youtu.be/IulcfUm-cUM
  4. Question on fixed mag in MA

    Fixed mag AR’s are horrible. Why do you want to to that? Also I believe the lower has to be manufactured as a fixed mag lower. Not modified after the fact.
  5. Bent decapping pins

    Thank you. I will look out for them
  6. Bent decapping pins

    Off of the floor at MRA
  7. Bent decapping pins

  8. Bent decapping pins

    It’s a little beat up from me messing with it after it broke the pin
  9. Bent decapping pins

  10. Bent decapping pins

    No it was definitely seated right, I ran into that issue previously and it took me a little bit to figure out why the primer wasn’t popping out. But it was like you suggested, buried in the die. But that wasn’t the issue today
  11. Bent decapping pins

    I can’t tell because I can’t get the primer out at all. I even tried to use a hammer and a punch and it’s not budging. the inside of the case almost looks like a solid piece of metal along the bottom When I was De-priming, I didn’t have my glasses on so I never even looked inside the case
  12. Bent decapping pins

    I am new to this and I have bent 3 decapping pins recently I’m using a Lee single stage press and Lee dies. After about 2k rounds, my first pin bent. Then I bought replacements and just bent 2 (after about 500 more) I’m not sure what I’m doing wrong. any suggestions? michael
  13. Kel Tec is making a 5.7x28 pistol that uses P90 mags

    Is this a solution to a problem that doesn’t exist?
Top Bottom