Recent content by 01SVTvert

not anything I could do. It sits at the back of the safe now.

In

I have a new unopened 8lb jug of HP38 I will trade for the same amount of powder usable for 223 reloading. Preferred TAC or H335 but will considers others. HP38 is new production. Contact by PM here is best Have a LTC Meet near Worcester. As always, goose rules apply and all laws...

Two boxes S&B large pistol primers $150 / k Two boxes CCI BR-2 Large rifle benchrest primers. $170/k Meet near Worcester / Leominster area Must have LTC. Cash only message here for response

Warbird leather if you don't mind spending some money. Custom made , colors, types of leather,etc

SBS is a "firearm" under MA law and since it is not on the roster a dealer is not supposed to transfer it. Healy rule which actually under strict interpretation is correct. Good luck.

I sourced all my parts from ebay. Only problem is I had to look up the directions for the PID by googling the PID type. Easy enough to do, though.

As I said. everyone who has joined for the last several years plus is told that exact thing by Dan at the membership meeting. that would be more than one thousand people at a minimum. He uses a chencklist of points that he goes over during his talk. Every member that joins must go to the...

During the intro talk Dan gives at every meeting it is mentioned that's drawing from a holster is reserved for the action pits including th SASS pits. Anywhere that has benches to shoot From is supposed to be for firearms out on the bench and not from holsters. I have heard that speech dozens...

Circle C Mark on the barrrel is considered a sign of a Fake sniper. Ukraine made fake. You can research it some more but IMO it's fake

Edit. The markings should include a "CH" on the barrel to designate a sniper. I don't see that so I will say my initial opinion is suspect. Who is marked as the importer? That is a genuine scope and a genuine sniper IMO. The mount is serialized to the rifle as it should be. Does the...

Trailboss with a lead 200gr cast bullet. Lubed and gas checked. Next up is trying to powdercoat them. Sight goes at the 300m? setting to get close to zero. Tried 4895 and had squibs and hangfires. I have plenty of trailboss so I will just use that.

Break them all down unless its cheaper to buy a new $1k pistol. If not then shoot away with a glove, ear pro and a welding mask. Start by doing 100 at a time and checking each 100. Better when there is a problem to pull 100 than 500. My top was pulling 200 with a kinetic puller over...

In

Happens to me occasionally too. You expect the RMV computers to be accurate!?!? HA.